Shop Talk Live - Fine Woodworking

Question 1:

From Al: I am having some trouble laying out the pins and tales on the Wenge in the more traditional way, unlike what Mike shows.  Wenge is extremely hard and not at all forgiving and the grain tends to be a problem in scribing the wood. Perhaps this is why he choose to do this with the table saw and router methods as shown on Rough Cut.  Where can I get the table saw blade and the router bit to do it like Mike. He always has great ideas that are very valuable.

  • The Whiteside router bit Mike mentions can be found here

Question 2:

From Madison: I was wondering how long it took Mike to build the tea box featured in magazine issue 269.  

Segment:  Ben: Steam bending everything!

Question 3:

From Matt: How would someone go about preparing kumiko strips without a tablesaw or drum sander?  


Every two weeks, a team of Fine Woodworking staffers answers questions from readers on Shop Talk Live, Fine Woodworking‘s biweekly podcast. Send your woodworking questions to shoptalk@taunton.com for consideration in the regular broadcast! Our continued existence relies upon listener support. So if you enjoy the show, be sure to leave us a five-star rating and maybe even a nice comment on our iTunes page.

Direct download: shop-talk-live-episode-188-pregame.mp3
Category:general -- posted at: 11:00am EDT

Question 1: From Paul: Heide Martin’s serving trays in the May/June 2018 are beautiful and I have since made a couple. My question is about keeping the bottom boards flat. I cut some walnut that had been air dried for probably 20 years. In an hour or two both boards cupped. I then sequentially tried wetting one side, wetting both sides, soaking in water, soaking in fabric softener, each time clamping the boards to keep them flat and leaving for days and days to dry out. None of these things worked and in the end I ended up using some walnut plywood instead. How do you folks keep wide, thin boards flat?

Question 2: From Richard: In reality we all have limited amount of shop time available.  However, if the amount of time you could work on a project was not limited what one piece would you choose to make?

Segment: All-Time Favorite Technique

Mike: Using pocket holes to quickly make and change full-size mockups

Tom: Beveling an edge of a workpiece with a handplane

Ben: Riding the back of the blade to start a cut on the edge of workpiece

Question 3:   From Mark: I have been building furniture full-time for just over a year. Is it legal and/or ethical to build something from the magazine or a video workshop and then sell it? For instance, if a client asks me to build 4 Adirondack chairs, my thought is build them loosely based on what I find at Fine Woodworking, vs. reinventing the wheel with my own design every-time.

Question 4: From John: I was reading a FWW article by Steve Latta in issue #241 about draw-bored tenons where he said, “I make pins from riftsawn or quartersawn stock...”. If you’re making dowels, how can it possibly make any difference whatsoever if you use quartersawn or plain sawn boards? I still like Steve Latta, btw.  Keep up the great work, see y’all at FWWlive!


Every two weeks, a team of Fine Woodworking staffers answers questions from readers on Shop Talk Live, Fine Woodworking‘s biweekly podcast. Send your woodworking questions to shoptalk@taunton.com for consideration in the regular broadcast! Our continued existence relies upon listener support. So if you enjoy the show, be sure to leave us a five-star rating and maybe even a nice comment on our iTunes page.

Direct download: shop-talk-live-episode-187.mp3
Category:general -- posted at: 11:24am EDT

1